Search the Community
Showing results for tags 'neck'.
Found 2 results
-
Hello members, I recently acquired an Obitsu 60cm body along with a head I've been searching for. Unfortunately, the seller insisted on selling the head and body together, leaving me with no choice but to purchase the entire set. The part that allows for attaching a Volks head is broken, and I'm in need of guidance on where to find a suitable replacement. If anyone has suggestions or knows where I can acquire a new neck peg, I would be immensely grateful. I don’t know anything about Obitsu bodies and I might sell it fast but if I can replace the neck peg easily I will maybe keep if after all. Thank you 🙏🏻✨
-
So I'm pretty new to this hobby and just received my first doll, a Parabox Akari head with a 27cm Obitsu body, and was wondering how loose the head should be since I have no experience (I don't want to mess it up, either!). Right now her head is mostly stable and turns right to left without any issue, but is perhaps a little loose in holding up/down facing positions. I'm not sure how to explain it - basically it takes only a light touch for her head to tilt a little downwards again, and those poses aren't held as strong as right/left facing poses. Is this typical for these bodies? I did notice that the neck joint (I think that's what you'd call it) seemed a little wiggly on its own too. Overall it's not a huge issue but something I want to make sure I'm doing right. I screwed the neck piece in for what seemed like quite a while trying to make sure it was tight enough, and made sure the neck was placed snugly up against the base of the head. I selected the largest neck piece included as well, as it was the one that kept her head the most stable when I screwed it in as far as I could. I was also unsure of what the different sizes of neck pieces mean - the ones that go in the head and are screwed in. Any help would be greatly appreciated!!
.thumb.jpg.c5a860659a435d9054c671779c7a7d64.jpg)