Mew Posted April 23, 2013 Does anyone have a tip on opening closed eyeholes? The head I want in only in stock with closed eyeholes. Thanks in advance! :3 Share this post Link to post Share on other sites
XOHimitsuOX Posted April 23, 2013 Drill a few holes about 2mm away from the edge of the eye socket and use hobby clippers to remove the center. Next use an exacto knife to slowly shave small pieces off. Take your time and don't cut too much. There's no going back if you remove too much. Share this post Link to post Share on other sites
Yukamina Posted April 23, 2013 I use an exacto knife from the start, and then sandpaper to smooth the cut marks. Go slowly and be very careful! My Etsy Shop ~~~ My DeviantArt Share this post Link to post Share on other sites
TheWhiteRabbit Posted April 23, 2013 I used a little exaco knife to open up my DDH01. Pierce the center (carefully!!) and slowly cut away the inside and clean up the edges. You might need to sand away some roughness inside the eye hole. Follow me on Twitter https://twitter.com/WhiteRabbit887 Follow me on Instagram https://www.instagram.com/whiterabbitdolls?igsh=czQyZzRweG9hZDM2 Share this post Link to post Share on other sites
